I’ve been trying to experiment with TinkerCAD to model a 3D printable box for this project. I have the bottom of the case designed with the mounting holes for the Pi. I haven’t been able to figure out how to design the top of the case so that it snaps into place.
Here is a top view of the bottom part of the case.
Here is a top view at an angle.
I have no prototyped this so I can’t even say for sure that the mounting holes are correct, but I believe they are. I did make the holes slightly smaller to allow screws to bite into the plastic.
Related
Author: Tyler Morris
I am a graduate of the University of Pittsburgh at Bradford. I earned a B.S. in Computer Information Systems & Technology with a minor in Digital Graphic Design in Dec. of 2018. My focus is on computer repair and web design. I also earned my extra class amateur radio (ham radio) license in 2008. I currently spend my time helping other hams setup DSTAR/Digital repeaters, maintaining a local DSTAR hotspot, taking photographs, occasionally volunteering on committees at Pitt-Bradford, and keeping goldfish and koi.
View all posts by Tyler Morris
