Last week I decided to purchase a little board called an MMDVM_HS_HAT_DUPLEX. What I purchased is a cheaper clone, but it should work about the same as it uses the same firmware. Essentially it is a tiny low-powered repeater on a single circuit board. It is designed to be a personal duplex hotspot.
The board has an STM32 microcontroller and two ADF7021 radio microchips. The board should produce about 10mW of RF power output. The board has a number of LED’s to indicate various things such as, power, carrier operated squelch (COS), Push-To-Talk (PTT), and an LED for each digital mode the board is capable of such as DSTAR, DMR, YSF, P25, and NXDN.
The board is a hat so it sits directly on top of the Raspberry Pi and uses the Pi’s GPIO pins to communicate with the Pi-Star Software.
Fully assembled, this is what the Pi looks like with the MMDVM Duplex Hot Spot board attached.
The other piece of this project that I decided to add, was a screen. It has not arrived yet. This will solve the problem of not knowing the IP address of the Pi to connect to the dashboard. I did some reading and the MMDVM Duplex Board is capable of working with a small OLED display OR a Nextion touch screen. I opted for the touch screen which will give me more options for controlling the device. On most of the forums and Facebook groups for DSTAR hotspots, other hams seem to recommend the 3.5″ display most often. I opted for a slightly smaller 3.2″ display, specifically the NX4024K032_011R.
It’s slightly cheaper than the 3.5″ screen and slightly smaller. This is an enhanced version with more flash memory and more RAM than the basic models.
This display is a Human Machine Interface that is programmed using a piece of software called Nextion Editor. It’s a What You See Is What You Get (WYSIWYG) editor. The coding to make the screen work seems pretty simple, however I have not looked at the code in the Pi-Star software that actually sends the information to the screen.
Here I found a guide on using the Nextion Editor software, which I’m sure will be useful for creating my own display interface. Here is another guide on creating a screen layout/interface that is specific to the MMDVM and ham radio. The interface is designed, saved to an HMI file, and then compiled into a TFT file, which is then uploaded to the screen. You can upload the TFT file via a USB to TTL serial adapter or by using a microSD card with the TFT file on it, inserted into the microSD card slot on the Nextion Display.
You may also find *.TFT files that other amateur radio operators (hams) have made available on a few different MMDVM Hotspot groups. These files (as long as they’re made for the exact screen you’re using) can be downloaded to your computer and uploaded to your screen. If you can get the *.HMI file which is typically available with the *.TFT files, you can edit the HMI file in Nextion Editor to suit your needs and then upload it to your screen. Here is an example interface from the second guide that another ham has created.
Next week I’ll set up the MMDVM to work with the Raspberry Pi and update the MMDVM’s firmware.
