Week 8 – Setting TX & RX Offset

After setting up the MMDVM duplex hotspot board, it is necessary to adjust the transmit and receive offsets in the MMDVMHost expert editor section. Basically this corrects the transmit (TX) and receive (RX) frequency of the board, if they’re not on frequency.

I went to a fellow amateur radio operator’s house recently to test my board with his HP 8920A Service Monitor. According to this ham, the service monitor is about 30 years old and cost around $30,000 new. Every 2 years he has it calibrated to NIST standards and it is accurate to +/- 1 Hertz.

The back of the board recommends a TX and RX offset of 500 and then tells you to adjust until the BER or Bit Error Rate is less than 5%. With my friend’s help, I tested the output frequency of the repeater/hotspot board without setting any TX offset and the transmit frequency (FRQ) was about 442.999300Mhz. So I adjusted the TX offset to 500 and retested the transmit frequency. It appears to be getting closer, showing a frequency of about 442.999700Mhz. So I bumped the TX offset up to 800 and that brought the TX frequency up to approximately. 443.000000Mhz, which is right on frequency.

Setting the RX offset is a bit more difficult because there isn’t really a way to test that within Pi-Star. So, I transmitted to the repeater board with my DSTAR handheld and found that I had a bit error rate of 0.1% which really doesn’t need to be fixed.

0.1% Bit Error Rate

I set the RX offset equal to the TX offset (800) and that brought the bit error rate down to 0.0%, which is perfect.

0.0% Bit Error Rate

I also worked on installing the Nextion Display Driver, however I’m encountering problems with it. The screen layout disconnects from the MMDVMHost software every time the screen changes. I need to work on this a little bit more to solve that problem. I’m thinking the problem is the layout I used. I was testing with a layout from another ham that displays a lot of information and I think the screen has trouble keeping up with the amount of data. I will detail this process in my next post.

Author: Tyler Morris

I am a graduate of the University of Pittsburgh at Bradford. I earned a B.S. in Computer Information Systems & Technology with a minor in Digital Graphic Design in Dec. of 2018. My focus is on computer repair and web design. I also earned my extra class amateur radio (ham radio) license in 2008. I currently spend my time helping other hams setup DSTAR/Digital repeaters, maintaining a local DSTAR hotspot, taking photographs, occasionally volunteering on committees at Pitt-Bradford, and keeping goldfish and koi.

Leave a Reply

Your email address will not be published. Required fields are marked *